model 70 trigger job

[liquidorange]

is there any place i can download the info on how to do this myself. im good with tools and have ripped apart quite a few guns over the years but would like to try doing my own trigger job. looks easy inside. just 2 nuts a spring and a threaded screw with a slot on top. i see that you can buy a video for 30$ but i would think a good set of instructions would do the trick. thanks !

[Vapodog]

you need two small wrenches to fit the little nuts and a small (eyeglass) screwdriver.....I learned the old fashioned way.....I screwed around with it and it' s easy to learn....sorry, I have no download for you but just do it.....it' s easy to figure out once you' ve messed with it for a few minutes.

The nuts that compress the spring actually adjust the pounds of pull.....one other nut adjusts creep.....The M-70 is an easy gun to adjust.....when done cock the bolt with an empty chamber, close the bolt and drop the gun butt stock on the floor from about six inches and the firing pin must not fall.....play with this and insure that a slight fall will not fire the gun on fire position.

[down wind]

I just worked the trigger on my model 70. I got my info from http://www.snipercountry.com/Article...WinTrigger.htm
It worked well. Good luck

[liquidorange]

the article says there are 3 nuts mine has only 2. im gonna give it a try. if i dont think its right the local shop is getting 50$ .