HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)
-   Guns (https://www.huntingnet.com/forum/guns-10/)
-   -   TC Encore / Prohunter / 7mm STW (https://www.huntingnet.com/forum/guns/177622-tc-encore-prohunter-7mm-stw.html)

Allegiance05 01-28-2007 09:22 AM

TC Encore / Prohunter / 7mm STW
 
A questionfor all hopefully someone knows the answer. I am looking to get my Encore 7mm mag rechambered into a 7mm STW. Does anyone know if the Encore can handle the pressures of the STW. I have tried for months to find a barrel that this has been done to but have not had much luck as of yet. Any hekp or suggestions would be appreciated. I have sent a letter to TC but have heard nothing back yet.

Pighunter56 01-28-2007 10:05 AM

RE: TC Encore / Prohunter / 7mm STW
 
I agree with RR, the 7mm STW isn't a whole lot better then the 7mm Rem Mag, until you do looooooooong range shooting. You should just stick with what you have.

bigcountry 01-28-2007 10:53 AM

RE: TC Encore / Prohunter / 7mm STW
 
I have an STW, and really like it, but rem mag is superior for most hunters. A rem mag can do some amazing things bullistics wise, and with 10gr-15gr less powder.

Roskoe 01-28-2007 11:15 AM

RE: TC Encore / Prohunter / 7mm STW
 
In the 28" Pro Hunter barrel, the STW should be a formidable 7MM. In a 24" barrel, it's not much faster than a 7 Rem Mag. Pressure is pressure. Doesn't matter a whole lot if you are loading a 7MM-08 to 55K or a 7MM RUM to 55K. There shouldn't be any problem with rechambering as long as you don't wind up with a little bump where the old shoulder of the 7 Rem Mag was - you can look at the cartridge specifications and try to figure the diameter of the STW's case at that point - but sometimes factory chambers are a little fat and often gunsmith's reamers are a little tight . . . . . Problem with the Encore/Pro Hunter is that you have no ability to set the barrel back if this gremlin raises its ugly head. If you don't already have the barrel, a safer bet would be to start with a 7MM-08 barrel.

Allegiance05 01-28-2007 03:43 PM

RE: TC Encore / Prohunter / 7mm STW
 
Thanks for your info / insights. I have an 7mm STW in a Sako already and really love it. I thought if I could get a bareel done in an STW all the better.

PaJack 01-28-2007 05:43 PM

RE: TC Encore / Prohunter / 7mm STW
 
Check out this company,the make the 7mm STW for the Encore...;)

http://www.matchgrademachine.com/

handloader1 01-28-2007 10:53 PM

RE: TC Encore / Prohunter / 7mm STW
 
You can also check with www.reedercustomguns.com (928-526-3313). Good luck.


All times are GMT -8. The time now is 05:02 PM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.