m14 disassembly....
#1
m14 disassembly....
my dad just brought home a M14 and was cleaning the grease out of it before shooting....and he couldnt figure out how the bolt comes out...he got the trigger out...and stock and barrel and receiver seperated..but cant get the bolt out.....hes usually good with disassemblys....but never played with an m14...wondering if theres a trick to it or a certain way to do it that you guys may know?? thanx....figured id ask...alot of you guys seem to know stuff that alot of people dont
#2
Join Date: May 2003
Location:
Posts: 198
RE: m14 disassembly....
Well first off if your Dad brought home a "true" M-14 which is a selective fire weapon then unless he did the correct paper work and payed the transfer fee or is a class 3 or above dealer then it is an illegal rifle and my addvice would be to turn it in!!!! On the other hand I am sure it is a legal rework or an M1A which is fine. Stripping them is all the same, to get the golt out lay the barreled action up side down on a table and remove the guide rod and recoil spring. If you look at the bottom front of the reciever you will see a pin which goes through the guide rod, compress the spring and push the pin to the side. You can now remove the spring and guide rod but hold on to it or it goes flying. Next, move the opperating handle to the rear putting down ward pressure on it and it will snap into the dissambly notch. Rotate the opp. rod outwards and it will clear the bolt which now can be fiddled with and removed.
#3
Join Date: Jan 2005
Location:
Posts: 505
RE: m14 disassembly....
Go here.....pictures and all. Regards, Rick. http://www.surplusrifle.com/m14m1a/rifledisassembly/index.asp