QAD Ultra Rest NOT fitting a Bowtech?

demoIL · 01-12-2009, 04:15 PM

I have had more issues here lately than I ever had.. lol geeez!

I ordered a new Ultra Rest HD for my new Bowtech Admiral.. Has anyone had issues with these fitting on their bow?

I had to use a spacer block which is provided and ok that's fine.. But the mounting block on the HD is shorter than the mounting block on the LD and I can't get the mounting block level on the bow. I run out of adjustment. It's all the way back and on the rear mounting hole but the piece that the arrow capture bar mounts on is hitting on the riser and I cand go out or up anymore..

I was just curious if anyone else has had this problem..

SwampCollie · 01-12-2009, 04:25 PM

I did a post on the technical forum back in november on how to properly set up a drop away rest... and I used a QAD Ultra Rest HD and an Admiral for my demo. I've sold close to a dozen of them already, and I think all but two I've put Ultra Rests on. No issues what so ever.

I'll dig that post up and put a link on this thread for you.

SwampCollie · 01-12-2009, 04:28 PM

Here you go demo. If you have any questions bro don't hesitate to PM me..... afterall... I do this for a living.

http://www.hunting.net/forum/tm.aspx?m=3170417

Good luck.

demoIL · 01-12-2009, 05:27 PM

The mounting block on that one is much longer than the one I have, not sure why.. I'll see if I can send you a pic of it..

(Been contacting qad and can't seem to get a response)

demoIL · 01-12-2009, 06:08 PM

Well I couldn't attach the picture by using the email shortcut in your profile so here it is.. If you want the full size file let me know and send your email..

I really appreciate the help by the way..

As you can see it's all the way back. The one you have in your post has a longer mounting block..