Hoyt one piece quiver

Hoyt_Viper · 07-02-2008, 11:32 PM

After shooting the past few times, by bow seems to make more noise than normal with two, or even one arrow left in quiver. I have the Hoyt one piece, sould a two piece be that much quiter?

I have inserted rubber between the tighten bracket for the quive, but I think the problem is in the foam tip cover. Can you replace these foam tip cover in quiver, or would it be best to change to a two piece quiver?

Anyone experience an older quiver being the culprit...and a two piece making the difference/

MECHDOC · 07-03-2008, 12:20 AM

Yes you can just replace foam.If the rubber shaft clamps are loose its garbage unless you use larger dia. shafts.The two piece quivers are nice but a good quality detachable will work just as good.

racewayking · 07-03-2008, 06:56 AM

I like the detachables, hanging a bow with the quiver can be a pain.

strutnbuck · 07-03-2008, 08:44 AM

I bought the FUSE 1 piece instead of the Hoyt/ $20 difference. I have absolutly no more noise iwth the quiver on than with out it.

Hoyt_Viper · 07-03-2008, 10:01 PM

Mine is the detacheable one piece. Where it attaches and has the large wingnut to tighten I have placed two thin rubber sheets to dampen, as well as hold the tightness of the wing nut..

My problem is when I placed my fixed broadheads in it last year, it made for extra wide holes and quite a TWANG for field points while practice shooting. Im planning onremoving foam tip holder to accomodate field points now, until season, and then tear it up with the Muzzy;s and slick Tricks.

Is this usually an order part from hoyt or can I buy some of that foam spray and refill the point part of quiver. As much as I would like to buy a two piece, I like the fact that mine is removable, and my bling is done on other projects. Anyone used the spray foam to replace the foam that came with their quiver?

virginiashadow · 07-03-2008, 10:04 PM

I have the two piece quiver...was expensive as heck but is quiet.

strutnbuck · 07-04-2008, 07:33 AM

Hoyt my Fuse is removable as well. I bought a receiver that I attatch to my tree and when I get in my stand, the quiver gets taken off. Not because of noise, but I prefer shooting with it off. I would imagine you could contact Hoyt and see if they sell just the foam, but if not, i would think it would be ok to use the spray foam, but you will probably ware it out quick, especially when using broadheads!

Bowman4440 · 07-04-2008, 07:41 AM

My hoyt came with the 2 piece quiver. It was quiet but I take off my quiver to shoot. In the stand you jsut hang it on a lim or screw a hook into the tree. It makes the bow more manuverable and it cuts noise also.