SPine selector

Oneshot7 · 02-07-2008, 04:41 PM

Does anyone have the link to that ontarget system or another good sine selector chart. I think I am talking about the right thing.

Deleted User · 02-07-2008, 04:54 PM

[Deleted by Admins]

mobow · 02-07-2008, 05:32 PM

Quote:

ORIGINAL: DropTine249

I think Easton has one on their website.

They used to, I'm not sure what they did w/ it...I've looked everywhere, it's not there. I found the '06 selector, but it's not live anymore.

MO_Bowhnter · 02-07-2008, 05:42 PM

Shoot me all your specs 1shot, and I'l run them through ontarget for you and see what comes up.

Oneshot7 · 02-07-2008, 07:18 PM

65 lb Ally with with a 75 or 100 gr tip @ 28.5 in ( any thing else you need to know buddy)

Roskoe · 02-07-2008, 08:11 PM

You are kinda close to the split between a 400 series and a 340 series - which means you need a 340 series. I might cut them a little long just to be on the plus side. If you could get by with a shaft shorter than 28", you could use a 400 series - particularly with 75 gr. heads.

MECHDOC · 02-07-2008, 08:23 PM

I think this is what your looking for.http://www.pinwheelsoftware.com/

MO_Bowhnter · 02-07-2008, 08:25 PM

Quote:

ORIGINAL: Oneshot7

65 lb Ally with with a 75 or 100 gr tip @ 28.5 in ( any thing else you need to know buddy)

Draw length is 28.5?

Oneshot7 · 02-08-2008, 07:05 PM

yea mo

Deleted User · 02-08-2008, 07:20 PM

[Deleted by Admins]