nock bushings for carbon express

[JoshKeller]

anyone know what size bushings will fit the carbon express terminator lite select shafts? Getting tired of getting nocks busted off at 3d tournaments.

[mobow]

I can tell you that the 250 are a differnt size than the 350's......But the terms are rated 4560 and 6075.......I don't know which ones you are shooting, but try the collars for a 250 if you are using the 4560's, and the 350's for the 6075's.....

CX also makes their version of the pin nock....Those would would be better for what you're wanting.

[Matt/TN]

I believe a 3-60 uni bushing will fit a 250. They did mine anyway.



Those bulldog collars, were a bit overrated in my opinion, they definately aren't going to protect your nocks, nothing is going to do that. The collars just seem to protect the "glance offs"

[mobow]

The collar was never intended to protect the nock, just the end of the shaft, which it does extremely well.

I don't know why I didn't think of that, but you're right...The 3-60 bushing will fit, and it will probably fit the 350 as well. I bet that's what you'll need, unless you decide to go w/ pin nocks.

[Matt/TN]

ORIGINAL: mobow

The collar was never intended to protect the nock, just the end of the shaft, which it does extremely well.

I don't know why I didn't think of that, but you're right...The 3-60 bushing will fit, and it will probably fit the 350 as well. I bet that's what you'll need, unless you decide to go w/ pin nocks.

I don't know about the 350's but the 3-60's worked pretty well in my 250's.

[JoshKeller]

I'm shooting the 60/75's I'm not worried about the nock, its cracking the end of the arrow thats getting on my nerves, and my wallet!

[mobow]

That is exactly what the collars are intended.....Give the 350's a try, I think they will work.