cvx wolf sight in

stcspiderman · 11-19-2010, 05:45 PM

What way do you move the sight go up or down where should I be hitting at 100yds. my longest shot might be 200yds. say if i am in the bullseye at 100yds would i be at 200 150.

MountainDevil54 · 11-19-2010, 06:04 PM

Open sights,you move the sights in the direction that you need to go.

where the bullet impacts at 150-200 Depends on the load you are using.

cayugad · 11-19-2010, 06:39 PM

You move the REAR sight the direction you want the bullet to travel. So if your hitting to the left and want your group to move to the right, move the rear sight to the right. If you're hitting low and want to move the POI up, move the rear sight up the ramp.

Roger46982 · 11-19-2010, 11:45 PM

Don't know about you but with my old eyes or when I was younger for that matter, I would be lucky to even hit a deer with open sights at 200 yds.

SuperKirby · 11-20-2010, 06:31 AM

Totally off topic, but you don't happen to know stc superman do you? I haven't seen him for awhile.

stcspiderman · 11-21-2010, 05:50 PM

OK I like to know, is the gun I have messed up.

I am shooting the power belts with two 777 50 grain equal 100.

I have CVA wolf 2010 model, I shoot at 25yds get 2 shots in bull’s eye so I move out 50yds shoot nowhere on paper. 8x11 paper
why is this what could be wrong

MountainDevil54 · 11-21-2010, 06:57 PM

could be over shooting

stcspiderman · 11-21-2010, 09:24 PM

over shooting, What do you mean by this?

MountainDevil54 · 11-21-2010, 09:50 PM

when i sighted in at 25 yards, dead on, i pulled back to 50 yards only to find out that i was shooting 7" high.

Try a bigger target so you can figure out where your shots are impacting.

UncleNorby · 11-22-2010, 04:32 AM

Most people see good accuracy with powerbelts, but some have seen bad performance on deer with 100 gr loads and close shots.