I always remove the barrel from the stock, then spray the insides with Birchwood Casey Solvent. After it soaks in for a while I spray once more and then start running a brush down it. After I have done that for a while I like to run a few patches through with the same solvent. Then some dry patches.
If it is real bad, I break out the JB Bore paste and use that. Normally that will make the barrel shine again. Granted it will not do anything for pitting, but it will pull the rust out of the pits.
__________________
"Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well preserved body, but rather to skid in sideways, a total wreck, screaming Yahoo, with a big smile on your face."
|
rust removel in barrel ?
