Question

bozeman · 08-07-2008, 10:24 AM

I have a TC Encore 50 cal and have purchased a SIMS recoil pad. I have a synthetic stock, but can't get the screws out of the encore recoil pad to re-use in my SIMS recoil pad. Anybody else have this problem?

Bozeman

goatbrother · 08-07-2008, 11:17 AM

Why can't you get them out? Find the slits cut when installed and pull them out, may need to put some lubricant in there, try some needle nose pliers.

bozeman · 08-07-2008, 02:49 PM

I have, them things are stuck tight. Just wandering if something was holding them in that I needed to remove.

bozeman

lemoyne · 08-07-2008, 04:02 PM

I usually open the vise jaws a ways put the hole the screw should come out of over the gap and hit the screw with a board they will pop right back out with out chewing anything up. Lee

bozeman · 08-07-2008, 04:13 PM

I had to actually use a blade to cut the screw hole in the recoil pad a little bigger before the screws would come out. Got it, finally!

thanks,
bozeman