Traditions Pursuit LT - Custom Ramrod

[randyh]

I am looking at getting a custom length ramrod (tapped 10/32 both ends)for my Pursuit LT, to which I will attach a spinjag. The spinjag will be permanently left attached for loading/spit swabbing while in hunting situations. Due to the design of the Pursuit, I realize that a custom length rod with the spinjag attached will only be barely longer than what is needed to load the gun, if I wish to keep the overall length no longer than the barrel length. Based on my cuurent sabot/bullet and 2 - 777 pellet load, probably no more than 3/8 to 1/2 inch will stick out after seating the bullet.

Can anyone suggest a source for custom ramrods, preferably mid-west or northern part of the US?

[arcticap]

You might want togive this reputableoutfit located in Mingoville, PAa try for custom ramrods made from several different materials:

http://rmcsports.com/catalog.htm

Click on "ramrods & accessories" in the left hand column.

[randyh]

ORIGINAL: arcticap

You might want togive this reputableoutfit located in Mingoville, PAa try for custom ramrods made from several different materials:

http://rmcsports.com/catalog.htm

Click on "ramrods & accessories" in the left hand column.

contacted them and they are prepared to make what I need, and ship to Canada.

Thanks arcticap

[sabotloader]

randyh

Check this last post of mine out -

You can build your to any length you want and install the spin jag permanently....

http://www.huntingnet.com/forum/tm.aspx?m=2466396&mpage=1&=#2470318

The picture show the rod I bulit under a traditional gun but I do the same for all of inlines also...

[lemoyne]

3/8 aluminium doll from hardware or building supply cut to lenght center bore and tap and wala new ramrod. Lee