This is just an idea I was playing with, and it worked out pretty good.
It sure beats trying to pick primers out of a box one at a time.
So I thought would pass it along.
I used a small cedar block, 1/4" drill bit, plastic coffee can lid, a small wood screw, and some cotton.
I drilled the holes to just less than the depth of the primer so the flange
would stick up a bit. Some of them I went to deep onand I placed cotton
in the holes to raise the primers to the desired height.
Then I placed the block down on the coffee lid and marked it and cut it
out. Then centered that peice on the block cut the "V" notch and added
the screw. And that was it.
This one is about the size of a snuff can.
Have fun.
209 Homemade Trinket
